When each one is the right buy

Custom shaft or catalog shaft

Buy catalog shafting when a plain or keyed bar at a stock diameter does the job. Have the shaft made when it needs steps, fits or features the catalog does not sell, or when finishing a stock bar yourself costs more than the difference.

Catalog shafting is bar: one diameter, one tolerance along its whole length, sometimes a keyway. It is the right answer more often than a machine shop likes to admit. A line shaft, a guide rod or an axle that runs in pillow blocks rarely needs anything else.

A made-to-order shaft earns its price when the part has shoulders, when two diameters need different fits, or when the keyseat, thread and snap ring groove have to land where the mating parts are. Those are the features that turn a length of bar into a part, and someone has to cut them either way.

Configure a part →

How the two compare

Catalog shaftingShaft made to your dimensions
DiametersStock bar sizesAny diameter in range, stepped where you need a shoulder
LengthStock lengths, or cut to lengthCut and faced to your length tolerance
FitsThe tolerance the bar is sold to, the same along its lengthA tolerance or ISO 286 fit class on each diameter
FeaturesPlain, or keyed full lengthKeyseats, threads, grooves, holes, flats, knurls and tapers where the print puts them
DeliveryUsually from stockMade to order
Price for one pieceLowestHigher. You pay for the turning, not only the bar
What you still have to doAny machining the part needsNothing. It arrives finished to the drawing

Standard parts you can load and change

Part familyStandard parts loaded
Cylinder Parts37
NEMA Frame Sizes71
ANSI Pump Shafts25
Gear-Box Plug-In Shafts25
Thread-Mount Idler Shafts14
Mixer & Agitator Shafts44
Rigid Flange Coupling Hubs7
Set-Screw Shaft Collars8
CEMA Screw-Conveyor Shafts35

The 266 parts in the catalog are made to order like any other shaft. They save you entering the dimensions; they are not held in stock.

Part of Getting a price on a custom shaft. Other pages in the series: What it costs · Lead time.

The honest test

Price the stock bar, then add what it takes to finish it: your time or a local shop's to cut it, face it, turn the journals and mill the keyseat. If that comes to less than a finished part and you have the machine time, buy the bar.

If the stock bar needs more than a saw cut and a keyseat, or the part has a bearing fit that has to be right the first time, the made-to-order shaft is usually the cheaper one by the time it is installed.

A middle route

Many replacement shafts are a standard part with one thing changed: a longer extension, a different keyseat, a stainless grade. Load the standard part, change that one thing, and order it. You get a custom shaft without drawing it from nothing.

Frequently Asked Questions

When the part needs steps, a specific fit on a bearing or seal diameter, or features in set positions, and when machining a stock bar yourself would cost more than the difference in price. For a plain or full-length keyed shaft at a stock diameter, catalog shafting is usually the better buy.
For a saw cut and one keyseat, modifying stock is usually cheaper. Once the shaft needs turned journals, shoulders or more than one feature, add up the machining time before deciding; a finished shaft often comes out ahead.
No. They are made to order like any other shaft. The catalog loads the dimensions for you so you can order the part as it is or change it first.
Yes. Open it in the configurator and change any diameter, length, tolerance, material or feature. The drawing and the price update as you go.

These references are for specifying a part; every value here is one the configurator applies when you build one. Numbers are representative of the standard; check them against your part and its mating components before ordering. See all guides on the guides page.