Online configurator · no RFQ

Getting a price on a custom shaft

Build the shaft in the configurator and most parts show a price as you go. There is no drawing to upload and no RFQ to send. This page covers which parts price on the spot, which a machinist reviews first, and what comes with the order.

Standard shafts price instantly, no account needed. You enter the diameters, lengths, tolerances, material and features, and the configurator draws the part and prices it while you work. Change a diameter or add a keyseat and the number changes with it. When it is right, add it to the cart, or send it as a quote to whoever signs the purchase order. A few other configurations show their price once you sign in.

Not every shaft can be priced by a formula. A tight bearing fit, a fine finish, or a long slender part needs a machinist to look at how it will be held and cut. Those parts show a review pill where the price would be. Send it for a quote and we typically reply within one business day.

The table below is where that line sits today. The numbers are the limits the pricing engine itself applies, filled in when this page is built.

Configure a part →

What prices instantly and what is quoted

On your partPriced on the spotReviewed and quoted
Diameter and length tolerance±0.005″ or looserTighter than ±0.005″, which includes most bearing and press fits
Surface finish32 Ra or rougherFiner than 32 Ra
LengthUp to 50″Over 50″, or long and slender for the diameter
Diameter0.25″ and upUnder 0.25″
FeaturesMost, including Unified inch and metric threadsInternal keyways, splines, Acme and other trapezoidal threads, pipe threads

A part is priced on the spot only if every row lands in the middle column.

Before you order

What comes with the price

Every part generates a full engineering drawing as a PDF: dimensioned, toleranced, with a feature schedule. It is the same drawing that goes to the shop floor. Your quote or order also includes a 3D model of the part as a STEP file.

The minimum order is $50. There is no minimum quantity, so one piece is a normal order.

Starting from a standard part

You do not have to start from a blank shaft. The catalog holds 266 standard parts, such as NEMA motor shafts, pump shafts and gearbox shafts, each loaded with its dimensions. Open one, change what is different about yours, and the price follows.

Frequently Asked Questions

Yes. Enter the diameters, lengths, tolerances, material and features and the configurator draws the shaft and prices it as you go. Parts with tolerances tighter than ±0.005″, finishes finer than 32 Ra, or certain features are reviewed by a machinist and quoted instead, typically within one business day.
No. You enter the dimensions and the configurator generates the drawing. Every part comes with a dimensioned PDF drawing and a STEP file.
Yes. There is no minimum quantity. The minimum order is $50.
The price bar shows a review pill instead of a number. Send the part for a quote and a machinist reviews it; quotes typically come back within one business day.

These references are for specifying a part; every value here is one the configurator applies when you build one. Numbers are representative of the standard; check them against your part and its mating components before ordering. See all guides on the guides page.