Single-piece prices · what moves them

What a custom shaft costs

The price of a machined shaft comes from the bar it is cut from, how much of that bar is turned away, how tight the tolerances are, the finish, the features, and how many you order. Here are current prices for one piece, and what moves them.

The first table is not a list of examples picked to look good. It is every standard part in the catalog that shows a public price, grouped by family, priced for one piece exactly as the part loads in the configurator. The pricing engine produces these numbers each time the site is built, and they are the same numbers shown on each part page.

Your shaft will differ. Open the closest standard part, change the material or a diameter, and watch the price move. That is a faster answer than any rule of thumb.

Configure a part →

Price for one piece, by part family

Part familyParts with a public priceLowest, one pieceHighest, one piece
Thread-Mount Idler Shafts14$175$269
Cylinder Parts31$181$321
Mixer & Agitator Shafts4$244$246
CEMA Screw-Conveyor Shafts35$256$938

Lowest and highest price for a single piece, as loaded, among the parts in each family that show a public price.

What moves the price

What you changeWhat it does to the price
MaterialFree-machining steel cuts fastest. Alloy and stainless grades cost more as bar and take longer to turn.
Diameter and lengthMore bar, and more of it turned into chips. A stepped shaft starts as bar at its largest diameter.
ToleranceTighter tolerances take more care to hold and to measure. Past ±0.005″ a machinist reviews the part before it is priced.
Surface finishEach step down in Ra is a slower pass. Ask for the fine finish on the bearing and seal diameters and leave the rest standard.
FeaturesEach keyseat, thread, groove, cross hole or flat is another operation on the part.
QuantityThe price per piece drops as the quantity goes up. Change the quantity in the configurator and the unit price moves with it.
SpeedRush manufacturing carries a surcharge. See the lead time page.
PaperworkMaterial certification is +$15 per material and a certificate of conformance is +$50 per design.

Part of Getting a price on a custom shaft. Other pages in the series: Lead time · Custom vs catalog.

Lowering the price without changing the part

Loosen what does not need to be tight. Hold the bearing seats and seal journals to the fit they need and let the diameters between them run at the standard tolerance and finish.

Then check the quantity. If you will need a spare, price two: the unit price is lower than it is for one.

Minimum order

An order has to total at least $50. There is no minimum quantity.

Frequently Asked Questions

It depends on the material, size, tolerances, finish, features and quantity. The table on this page lists current single-piece prices for the standard parts in our catalog, and the configurator prices your own dimensions as you enter them. The minimum order is $50.
Tight tolerances, fine finishes and extra features, because each one adds machining. Alloy and stainless grades cost more than free-machining steel. Size matters too: a larger or longer shaft starts as more bar.
Yes. The price per piece drops as the quantity goes up. Change the quantity in the configurator to see the unit price at each level.
The minimum order is $50. There is no minimum quantity, so a single piece is fine as long as the order reaches that amount.

These references are for specifying a part; every value here is one the configurator applies when you build one. Numbers are representative of the standard; check them against your part and its mating components before ordering. See all guides on the guides page.