Products

Every configurable part family, each a set of dimensioned starting points that open in the configurator.

Pick a family to see its standard sizes, or start from a blank part. Each starting point loads with its geometry, keyseats, threads and tolerances already set; material, finish and any added feature stay editable, and the drawing updates as you change them.

• Cylinder Parts 37 starting points Custom hydraulic and pneumatic cylinder parts: pistons, piston rods, rod glands, gland nuts, O-ring plugs, port flanges, and NFPA-T3.6.7 tie rods, sized to your cylinder.
• Motor Shafts 71 starting points Pre-built shaft starting points sized to standard NEMA MG-1 frame dimensions, with NEMA shaft extension tolerances pre-applied.
• Pump Shafts 25 starting points Replacement ANSI process-pump shafts dimensioned to the OEM frame: Goulds 3196 (ST through X17), the Goulds 3796 self-primer and 3996 vertical in-line (same power end), the Goulds clone cluster (Summit 2196, Griswold 811, PumpWorks PWA), and Durco Mark 3 (Group 1 through 3).
• Gear-Box Shafts 25 starting points Replacement plug-in output shafts for flexible-mount right-angle speed reducers.
• Idler Shafts 14 starting points Replacement thread-mount idler rotary shafts.
• Screw-Conveyor Shafts 35 starting points Replacement CEMA screw-conveyor shafts, drilled to the standard coupling-bolt pattern.
• Mixer Shafts 44 starting points Replacement mixer / agitator shafts that drive a propeller or mixing blade.
• Coupling Hubs 7 starting points Custom rigid flange coupling hubs, sized by bore.
• Shaft Collars 8 starting points Custom one-piece set-screw shaft collars, sized by bore.

Not a catalog part?

The families above are starting points, not limits. Any turned part within the published envelope can be configured from scratch, and the material guides and engineering guides cover the grades, fits, keyseats and threads you will specify along the way.